產品描述

Highlights

• USB High speed and high SPI performance, support up to 2Gb SPI Flash
• In-Circuit Programming: Program on board SPI Flash
• Off-line Programming: Program SPI Flash in the socket
• Start button feature: Able to Batch in the USB mode
• Standalone mode: Support Start button programming and IO Port programming.
• Program two Serial Flash memories
• Signal conflict protections
• Multi-Programmers Capability through USB
• Support 1.8V low voltage IC
• Support Windows 2003 and above
• Support both 32 and 64 bit OS
• Support 1 CS pin

 

High performance (25MHz, Single IO):

USB Mode	Reference IC	Density	(Program + Verify)
Memory size	W25X80VSSIG	8Mb	9s
	W25Q16VSSIG	16Mb	11.6s
	W25Q32VSSIG	32Mb	12.6s
	W25Q64FVSSIG	64Mb	31s
	W25Q128BVFIG	128Mb	61.7s
	W25Q256FVFIG	256Mb	89.2s
	S25FL512SAGMFI011	512Mb	147.4s

*Please note the programming and verify time will depend on different IC type; please refer to the IC specification before programming.

 

Hardware

SF600Plus is designed with ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status. Please refer to Table 1 for the SF600Plus 2x10 header pin out. DediProg also provides the SF600Plus ISP Cable which is used to connect the programmer to the 2X6 2.54mm ISP Pin Header on board, please refer to Table 2 for the SF600PlusISP Cable 2x6 pin out.

 

Table 1: SF600Plus ISP Header Pin Out (2x10)

1	Vpp	CS2	2
3	CS1	Vcc	4
5	MISO/DQ1	Hold/DQ3	6
7	Wp/DQ2	CLK	8
9	GND	MOSI/DQ0	10
11	NC	Reset/IO3	12
13	NC	NC	14
15	NC	NC	16
17	NC	NC	18
19	GPIO1	GPIO2	20

 

Table 2: ISP Cable Connector Pin Out (2x6)

1	Vpp	CS2	2
3	CS1	Vcc	4
5	MISO/DQ1	Hold/DQ3	6
7	Wp/DQ2	CLK	8
9	GND	MOSI/DQ0	10
11	NC	Reset	12

付款方式︰ paypal

產品圖片