Highlights
- USB High speed and high SPI performance, support up to 2Gb SPI Flash
- In-Circuit Programming: Program on board SPI Flash
- Off-line Programming: Program SPI Flash in the socket
- Start button feature: Able to Batch in the USB mode
- Standalone mode: Support Start button programming and IO Port programming.
- Program two Serial Flash memories
- Signal conflict protections
- Multi-Programmers Capability through USB
- Support 1.8V low voltage IC
- Support Windows 2003 and above
- Support both 32 and 64 bit OS
- Support 1 CS pin
High performance (25MHz, Single IO):
| USB Mode |
Reference IC |
Density |
(Program + Verify) |
| Memory size |
W25X80VSSIG |
8Mb |
9s |
| W25Q16VSSIG |
16Mb |
11.6s |
| W25Q32VSSIG |
32Mb |
12.6s |
| W25Q64FVSSIG |
64Mb |
31s |
| W25Q128BVFIG |
128Mb |
61.7s |
| W25Q256FVFIG |
256Mb |
89.2s |
| S25FL512SAGMFI011 |
512Mb |
147.4s |
*Please note the programming and verify time will depend on different IC type; please refer to the IC specification before programming.
Hardware
SF600Plus is designed with ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status. Please refer to Table 1 for the SF600Plus 2x10 header pin out. DediProg also provides the SF600Plus ISP Cable which is used to connect the programmer to the 2X6 2.54mm ISP Pin Header on board, please refer to Table 2 for the SF600PlusISP Cable 2x6 pin out.
Table 1: SF600Plus ISP Header Pin Out (2x10)
| 1 |
Vpp |
CS2 |
2 |
| 3 |
CS1 |
Vcc |
4 |
| 5 |
MISO/DQ1 |
Hold/DQ3 |
6 |
| 7 |
Wp/DQ2 |
CLK |
8 |
| 9 |
GND |
MOSI/DQ0 |
10 |
| 11 |
NC |
Reset/IO3 |
12 |
| 13 |
NC |
NC |
14 |
| 15 |
NC |
NC |
16 |
| 17 |
NC |
NC |
18 |
| 19 |
GPIO1 |
GPIO2 |
20 |
Table 2: ISP Cable Connector Pin Out (2x6)
| 1 |
Vpp |
CS2 |
2 |
| 3 |
CS1 |
Vcc |
4 |
| 5 |
MISO/DQ1 |
Hold/DQ3 |
6 |
| 7 |
Wp/DQ2 |
CLK |
8 |
| 9 |
GND |
MOSI/DQ0 |
10 |
| 11 |
NC |
Reset |
12 |
